metal wall forming machine, steel wall forming machine, metal sheet forming machine steel sheeting machine, steel wall roll forming machine.
The steel wall forming machine consists of one decoiler, one roll former, and one stacker. The steel wall forming machine is used to roll forming the steel sheets into profiled walls for pre engineering building (PEB). The profiled steel sheets with an enhanced strength can be used for long term wall panelling.
Process and Features of the Metal wall forming machine
Manual Decoiler — Guiding —Roll Forming — LengthMeasuring—Hydraulic Cutting—Runout Table
1. This M/C adopts inner-expansion manual decoiler. The diametercan be adjusted through the adjusting bolt according to the coil’sinner diameter. The operation is quite easy. The decoiling speed isto the main machine’s forming speed.
2. The main frame is structured by welding entire T shape steel.The side stands are welded on the frame, and to clear the stress byvibration in order to maintain the rigidity and stability of themachine.
3. The forming rollers are made of GCr15 bearing steel through aseries of heat treatment such as forging, distressing anneal, highfrequency hardening(the degreed is 8-10mm), backfiring,phosphorization etc. The surface of the rollers can reach therigidity of HRC58-62. All the forming rollers are process on CNClathe, by which the accuracy can be granteed.
4. The main shaft is made of 40Cr advanced alloy steel after aseries of heat treatment such as high frequency hardening,quenching and tempering etc and processed on lathe, burnishing thesurface, wire cutting the channel to make it high accuracy andlarge capacity.
5. Cut to length is the last process of this machine line. It cutsaccurately to any length you set on the PLC. The cutter consists ofHydraulic diver, profiled blade and cutter frame, and a trackingsystem.. The blade is made from Cr12 cold punching steel afterstrict process. It adopts 45 degree staggering cutting. This costsno waste and can hold the cutting profile a good shape. And thiscutting is of high accuracy.
6. The machine adopts Panasocnic PLC, touch screen, Panasonic VFseries Transducer and Omron encoder. The entire electric componentsare of good stability and long life.
Main Parameter of the Metal Roof Forming machine
1) Steel Material: Q235 Color Steel, Galvanized, Aluminum
2) thickness of material: 0.3-0.8mm
3) Feeding Width Max: 1250mm
4) Capacity of Decoiler: 5T
5) Inner Diameter of the Coiler: 500-600mm
6) Outer Diameter of the Coiler: 1800mm
7) Forming steps: abt. 12 steps
8) Driving System: Chain Transmission
9) Power of main motor: 5.5kw
10) Reducer: Cycloid Pin
11) Power of Hydraulic cutting Machine: 3kw
12) Forming Speed Max: 15m/min
14)Dimension Tolerance: Length±3mm, Rib Width±0.4mm, Width±5mm
|
|
Metal Wall Forming Machine Line Images
|
